Copy Program; Load All Preset Programs - Ada MP-1 Owner's Manual

The MP-1 is monitored at four points along the signal path for clipping via the front panel
CLIP LEDS. If the LEDS flash on and off while you play there is no need for concern. The
CLIP LEDS are there to help you pinpoint overload distortion in the event you are having
trouble obtaining a clean guitar tone. If you hear unwanted clipping and the LEDS flash while
you play, you should lower the level of the parameter which is clipping as indicated by the
CLIP LEDS.
STORE MODE:
1. Press the STORE button. It will light.
2. Press the BANK button, use the up or down arrow buttons to select the desired bank
number in which to store your program.
3. Press the ones digit (0 to 9) of the desired program number in which you want to
store your program. Your program is now stored.
If you store to a program number which currently holds a program, the original program will
be erased and replaced with the new program.

COPY PROGRAM

1. Call up the program number to be copied. (See "accessing programs" section of this
manual.)
2. Press the STORE button. It will light.
3. Press the BANK button, and use the up or down ARROW buttons to select the
desired bank number in which to copy your program to.
4. Press the ones digit (0 to 9) of the desired program number in which you want to
copy your program to. Your program is now copied.
LOAD PRESET PROGRAMS
There are 69 factory preset programs (1-69) that can be loaded from ROM into the internal
program memory via the front panel. Note: If you have your own programs in memory
numbers 1 to 69, loading preset programs from ROM will erase your programs.
LOAD ONE PRESET:
1. Select the preset you wish to load from ROM. (See "accessing programs" section of
this manual.)
2. Press the STORE button. It will light.
3. Press the BANK button and while holding the BANK button down press the number 4
button. The display will read "Preset Loaded." When the display returns to a blinking
program number, the selected factory preset has been loaded into the current
working register. Now you may store it.
4. Press the STORE button. It will light.
5. Press the BANK button, and use the up or down arrow buttons to select the desired
bank number in which to store your program.
6. Press the ones digit (0 to 9) of the desired program number in which you want to
store your program. Your program is now stored.
LOAD ALL 69 PRESETS:
1. Press the STORE button. lt will light.
2. Press the BANK button and while holding the BANK button down press the number 1
button.
3. The display will read "Presets Loaded" When the display returns to a program
number, all 69 factory presets have, been restored.
Page 7