Store Mode; Copy Program; Load Preset Programs - Ada MB-1 Owner's Manual

ADA MB-1 owners manual version 2
The MB-1 is monitored at seven points along the signal path for clipping via the front panel
CLIP LED's. If the LED's flash on and off while you play there is no need for concern. The
CLIP LED's are there to help you pinpoint overload distortion in the event you are having
trouble obtaining a clean bass guitar tone. If you hear unwanted clipping and the LED's flash
while you play, you should lower the level of the parameter just before the indicated clipping
point.
Note: Brief peaks of overload/distortion may not always trigger the clip LED's.

STORE MODE:

1. Press the STORE button. It will light. If you are in MIDI PRGM mode you will be
prompted to press the INTERNAL PRGM button first. (You can't store a program to a
MIDI program number!)
2. Press the BANK button, then use the up or down arrow buttons to select the desired
bank number in which to store your program
3. Press the ones digit (0 to 9) of the desired program number in which you want to
store your program. Your program is now stored.
Note: If you store to a program number which currently holds a program, the original program
will be erased and replaced with the new program.

COPY PROGRAM

1. Call up the program number to be copied (See "accessing programs" section of this
manual.)
2. Press the STORE button. It will light
3. Press the BANK button, and use the up or down arrow buttons to select the desired
bank number in which to copy your program
4. Press the ones digit (0 to 9) of the desired program number in which you want to copy
your program. Your program is now copied.

LOAD PRESET PROGRAMS

There are 79 factory preset programs (1-79) that can be loaded from factory preset ROM into
the internal program memory via the front panel.
LOAD ONE PRESET
1. Select the factory preset you wish to load into Internal program storage. (See
"accessing programs" section of this manual.)
2. Press the STORE button. It will light
3. Press the BANK button, and use the up or down arrow buttons to select the desired
bank number in which to store your program (0-25.)
4. Press the ones digit (0 to 9) of the desired program number in which you want to
store your program. Your program is now stored.
LOAD ALL 79 PRESETS
Note: This proceedure erases all internal programs stored in internal locations 1 through 79.
1. Press the STORE button. It will light.
2. Press the BANK button and while holding the BANK button down press the 1 button.
3. The display will read "PrESEtS LoAdEd", and then returns to play mode.
Page 12 of 22