Installation - Vision TECHCONNECT TC2-HDMIW20 Owner's Manual

INSTALLATION

Connecting Rx
1. PLUG IN TO POWER
2. CONNECT TO DISPLAY with included HDMI cable
3. TURN DISPLAY ON and select correct input
Connecting Tx
1. CONNECT INPUTS from source devices
2. [OPTIONAL] CONNECT OUTPUT to local display if there is one
3. PLUG IN TO POWER power button backlight changes from red to blue
When the Tx is powered on the Rx will automatically come out of standby. If the transmitter is
powered off the receiver will switch to Standby after 10 minutes automatically.
Connecting IR Blasters
It is possible to point your source remote control at the Rx, and it will relay the IR signal back to
the source/s wirelessly.
1. CONNECT IR EMITTER TO TX Cable has 3 x IR emitter diodes inline to control up to three
source devices. Position them directly over the IR receivers on the source equipment.
NOTE 1: The IR sensors support 36~56kHz (NEC, RC5, RC6) signal protocol. The default setting
is 47kHz. Some devices may not be supported.
8
TC2-HDMIW20_manual_en