Related Manuals for Vision TECHCONNECT TC2-HDMIW20
Summary of Contents for Vision TECHCONNECT TC2-HDMIW20
- Page 1 TECHCONNECT TC2-HDMIW20 OWNERS MANUAL www.visionaudiovisual.com/techconnect/tc2-hdmiw20 TC2-HDMIW20_manual_en...
-
Page 2: Declaration Of Conformity
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. All products are designed and imported into the EU by ‘Vision’ who is wholly owned by ‘Azlan Logistics Ltd.’, Registered in England Nr. 04625566 at Lion House, 4 Pioneer Business Park, Clifton Moor, York, YO30 4GH. -
Page 3: Place Of Installation
WARNING SIGNS If you detect an abnormal smell or smoke, turn this product off immediately and unplug the power cord. Contact your reseller or Vision. PACKAGING Save all packing material. It is essential for shipping in the event the unit ever needs repair. -
Page 4: Special Warnings
SPECIAL WARNINGS Never use this product near an aircraft or medical facility. It can cause interference. Use of product in the following locations may result in abnormal video and audio output: Product installed in the walls made of concrete • Product situated near refrigerator. -
Page 5: Transmitter ("Tx")
INTRODUCTION This product transmits uncompressed 1080p (60 Hz) video and audio content to a display wirelessly. It uses 4.9 GHz~ 5.9 GHz frequencies and it adjusts frequency automatically to avoid interference. It has built-in Omni-directional antennas and transmits up to 20 meters (66 feet) LOS (Line of sight) with no latency. -
Page 6: Receiver ("Rx")
RECEIVER (“Rx”) Mini-USB power input (5V/2A/10W) HDMI output (type A) Current Source indicator Source select button Power Button (blue when on, red when in standby) REMOTE CONTROL Power Button IR button (toggles IR blaster frequency 38/47/56kHz to match source device frequency. The default setting is 47kHz. -
Page 7: Wall Mounting
WALL MOUNTING The Tx and Rx can be wall mounted. DRY WALL INSTRUCTIONS: DRILL 2 X HOLES IN WALL INSERT PLASTIC RAWL PLUGS INTO HOLES INSERT SCREWS INTO PLUGS. LEAVE HEADS PROTRUDING HOOK INTO PLACE 47mm / 1.8” 141mm / 5.55” TC2-HDMIW20_manual_en... -
Page 8: Installation
INSTALLATION Connecting Rx PLUG IN TO POWER CONNECT TO DISPLAY with included HDMI cable TURN DISPLAY ON and select correct input Connecting Tx CONNECT INPUTS from source devices [OPTIONAL] CONNECT OUTPUT to local display if there is one PLUG IN TO POWER power button backlight changes from red to blue When the Tx is powered on the Rx will automatically come out of standby. -
Page 9: Operation
OPERATION CHECK REMOTE CONTROL Ensure the 2 x AAA batteries are loaded into the remote control. TURN POWER ON When mains power is turned on the Tx and Rx will automatically turn They can be powered on in any order •... -
Page 10: Status Indicators
INFO Press INFO button on remote control to see on screen display: • Signal Quality • Source • Channel • Resolution NOTE: The status of the Tx HDMI output cannot be displayed on the on screen display. Press INFO button again to turn on screen display off. STATUS INDICATORS Rx Power Rx Status... -
Page 11: Supported Resolutions
NOTE 1: If link does not establish the transmitter may be out of range. Adjust distance between Tx and Rx. The maximum video transmission range for 1080p content is up to 20m (66 feet) in line of sight (LOS). The minimum range is 2m (6.5 feet). NOTE 3: If no video displayed and on screen display says “Not Supported Format”... -
Page 12: Supported Audio Bit Rates
If Tx LED continues to flash slower than “no signal” mode), and there is no video or video is poor, then the resolution is not supported. Supported Mandatory CEA 3D Video Format Timings 1280x720p @ 50Hz Top-and-Bottom 1280x720p @ 50Hz Frame packing 1280x720p @ 59.94 / 60Hz Top-and-Bottom 1280x720p @ 59.94 / 60Hz Frame packing 1920x1080i @ 50Hz Side-by-Side (Half) -
Page 13: Troubleshooting
TROUBLESHOOTING If your system is not operating properly, please refer to the following information. Problem Correction • Check if the power plugs of transmitter/receiver are properly Power indicators not inserted into a functioning power outlet. lighting up First steps • Check the HDMI connection on the Tx •... - Page 14 • Check video resolution on source device is compatible • Ensure the transmission distance is less than 20m (66 feet) line of Poor image quality or sight intermittent video • Check audio system is not muted and correct input is selected •...
-
Page 15: Specifications
SPECIFICATIONS TRANSMITTER DIMENSIONS: 182 x 97 x 32 mm / 7.2″ x 3.8″ x 1.3″(length x width x height) RECEIVER DIMENSIONS: 95 x 95 x 32 mm / 3.7″ x 3.7″ x 1.3″ (length x width x height) PRODUCT WEIGHT: 400 g / ,88 lbs (set) CONSTRUCTION MATERIAL: Plastic COLOUR: White TECHNICAL DETAILS:... -
Page 16: Warranty
WARRANTY This product comes with a 2-year return to base warranty, effective from the date of purchase. This warranty applies only to the original purchaser and is not transferable. For the avoidance of doubt, this will be taken from the information held by the appointed national distributor at the point of sale.
Need help?
Do you have a question about the TECHCONNECT TC2-HDMIW20 and is the answer not in the manual?
Questions and answers