Motorola v3i Disassembly Manual page 20

Ajay16 Motorola v3i Disassembly Guide v1.0
Page: 20
Your lower housing should now look like this.
41. Get the PCB board and place it into the housing, push down
gently so that it slips in place.
42. Now get the plastic aerial covering and the aerial. Put one side in
and under the edge of the housing. Then bend out the opposite
side of the housing and let it clip in. Push down to make sure it's
all slipped into place. Then replace the rubber parts.
Compiled Exclusively for MotoModders.net