Motorola v3i Disassembly Manual page 27

Ajay16 Motorola v3i Disassembly Guide v1.0
Page: 27
56. Put the LCD unit into the new housing, then the camera unit in and
clip the connector back in. Stick the earpiece back down, press
down firmly with your finger (if the speaker is not sticky anymore
use some double sided tape).
57. Now get the new large flipper cover, and slide it into the left hand
side. BE VERY CAREFUL NOT TO CATCH THE RIBBON, YOU
MUST GET NOT CATCH ANY OF THE LAYERS OF RIBBON.
THE CUT OUT IN THE HINGE MUST GO BETWEEN THE
METAL CROSS PIECE AND BEHIND THE RIBBON YOU CAN
SEE AT THE BOTTOM.
58. Put the hinge back in the opposite side and replace the T3 screw
that holds it in place.
Compiled Exclusively for MotoModders.net