Preparation - Kenwood Nexedge NX-240 Instruction Manual

INSTALLING THE CHANNEL STOPPER
You can set the channel stopper position for channels 2, 4,
6, 8, 10, 12, and 14. Inserting the Channel stopper prevents
unnecessarily selecting channels which do not exist.
• Selecting a channel which does not exist causes a continuous
error tone to sound.
1 Set the Channel selector to channel 1, then pull the
Channel selector knob off the transceiver.
• If the Channel selector is not positioned at channel 1, the knob
may not install correctly and the channel may be unable to change.
2 Insert the channel stopper.
3 Set the arrow of the Channel stopper to the highest channel
number for the transceiver.
4 Reinsert the Channel selector knob.
INSTALLING THE ANTENNA
Antenna
2

PREPARATION

Screw the antenna into the connector on the
top of the transceiver by holding the antenna at
its base and turning it clockwise until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade your
transceiver's performance.
Channel stopper
Arrow