Lone Worker; Paging Call - Kenwood Nexedge NX-240 Instruction Manual

■ Key Lock with Status Memory
This operates the same as Key Lock except that when the
transceiver power is turned OFF and then ON again, the
keys remains locked.

■ Lone Worker

Lone Worker Mode is a safety feature built into the
transceiver. If the transceiver is not operated for a
pre-programmed period of time, the transceiver will emit a
tone and automatically enter Emergency operation. Press
this key to toggle the Lone Worker function ON or OFF.
■ Low Transmit Power
Each channel is programmed with either high or low
transmit power. On high transmit power channels, press
this key to change the transmit power to low power (you
cannot change low transmit power channels to use high
power).
■ Monitor
Press to deactivate signaling (QT/DQT, FleetSync
signaling, NXDN, etc.). Press this key again to return to
normal operation.
■ Monitor Momentary
Continuously hold down this key to deactivate signaling
(QT/DQT, FleetSync signaling, NXDN, etc.). Release this
key to return to normal operation.

■ Paging Call

Press to send a FleetSync or NXDN paging call to an ID
from the ID list.
■ Priority Zone-Channel Select
If the scan priority type is "Operator Selectable", press
this key in normal mode to set the current channel as the
Priority channel.
■ Scan
Press to start (or stop) scanning the transceiver channels.
9