JVC CH-X1500 Service Manual page 6

CH-X1500
2.3.3 Removing the fitting (See fig.10)
(1) Remove the screw E attaching the fitting.
(2) Release the two joints a on the top edge of the fitting, then
release the joints b at the left / right bottom edges, and
remove.
2.3.4 Removing the main board assembly (See fig.11)
(1) Remove the screw F attaching the power IC.
(2) Remove the four screws G attaching the main board as-
sembly, and remove.
(3) Disconnect the wire from connector CN602 on the main
board assembly.
(4) Disconnect the wire from connector CN501 on the main
board assembly.
(5) Disconnect the card wire from connector CN604 on the
traverse mechanism board assembly.
1-6
a
b
E
Fig.10
CN501
G
G
CN604
CN602
Fig.11
b
G
F
Main board assembly