JVC CH-X1500 Service Manual page 15

2.5.2 Mounting the lifter unit (See fig.35~37)
(1) Insert the shafts e of the traverse mechanism assembly
into the slide grooves f on the lifter unit.
(2) Move the hook of the lifter unit to the edge, and move the
sliding lever inside the side bracket unit to the edge as
well.
(3) With each hole and lever shifted to the edge, mount the lift-
er unit and side bracket unit from the side. (Check each at-
tached section, and check that the joint g of the lifter unit
is correctly inserted into the holes h of the side bracket
unit. After reassembled, check that levers move together.)
(4) Turn the lifter unit upside down.
As shown in Fig. 37, slide the lever 30 mm away from the
edge, and then mount the lifter bracket (L) assembly.
Fig.35
Lifter unit
L
g
L
Side bracket
f
f
h
Fig.36
Lifter bracket(L) assembly
Fig.37
CH-X1500
e
f
e
e
Traverse mechanism
assembly
1-15