Table of Contents
Advertisement
Structure Of The Wash Machine
WATER DRAIN HOSE
(PUMP MODEL)
WASH TUB LID
During operation, close the
wash tub lid.
LINT FILTER
This is used for gathering the
dregs which are made during
washing.
PULSATOR
BASE UNDER
Control Panel (Panel b Ass y)
1
Wash
2
1 INLET WATER
1
Connect inlet hose to supply water in the WASH
TUB or BASKET SPIN.
2
2 LEVER WATER SUPPLY SELECTOR
Left : water supply in the WASH TUB.
Right : water supply in the BASKET SPIN.
3
3 WASH TIMER
Use to select the desired time for washing or rins-
ing.
OVERFLOW FILTER
GUIDE
CASCADE
3
4
0
3
15
12
6
9
Spin
Wash Timer
2. EXTERNAL VIEW
SPIN DRYER LID
When you open this lid while the spin basket is spinning,
the spinning will be stopped by brake system.
SAFETY COVER
INNER LID
SPIN DRYER BASKET.
POWER CORD
The plug's shape may not correspond with this drawing.
"WARNING-THIS APPLIANCE
MUST BE EARTHED"
WATER DRAIN HOSE
(NON-PUMP MODEL)
5
Wash-Rinse
Strong
Off
Normal
Drain
Wash Action
Valve Selector
4
4 WASH ACTION
Use to select wash action. (STRONG", "NORMAL")
5
5 VALVE SELECTOR
Select "WASH.RINSE" for washing and rinsing, and
"DRAIN" to drain the water.
(In case PUMP MODEL turn on the drain pump)
"OFF" to turn off the drain pump. (Only PUMP
MODEL)
6
6 SPIN TIMER
Used to select the desired time for spinning.
6
0
5
1
4
2
3
Spin Timer
STRUCTURE
3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DWM-800C and is the answer not in the manual?
Questions and answers
How to change the wash capacitor in my daewoo dual washing machine
To change the wash capacitor in a Daewoo DWM-800C washing machine, follow these steps:
1. Unplug the Washing Machine – Ensure the machine is disconnected from the power supply to prevent electrical hazards.
2. Access the Capacitor – Locate the wash capacitor (part number 4509C11020, 20.8uF*2, 200V) inside the machine. It is typically near the wash motor.
3. Discharge the Capacitor – Use an insulated screwdriver to short the capacitor terminals carefully to discharge any stored electricity.
4. Remove the Old Capacitor – Disconnect the wires from the capacitor terminals and unscrew or unclip it from its mounting.
5. Install the New Capacitor – Attach the new capacitor in the same position and reconnect the wires correctly.
6. Secure and Test – Ensure all connections are tight, reassemble the machine, plug it in, and test the wash function to confirm proper operation.
If unsure, consult a qualified technician.
This answer is automatically generated
Help please My wash motor icode is T-W1S35ED050 but I don't know which is the capacitor rate for this motor. I hope someone could hep me