Speed Limiter; Park Brakes; Hydraulic Lift Lever - Jacobsen AR 250 Turbo Safety And Operation Manual

Hide thumbs Also See for AR 250 Turbo:

Table of Contents

Available languages

CONTROLS

6.6

SPEED LIMITER

The speed limiter (A) is operated by pivoting the

lever under the footpedal. When positioned under

the footpedal the machine is limited to cutting

speed, when not under the footpedal transport speed

is availabe.

6.7

Push the pedal forward (A) until it locks to set

parking brake. Release parking brake by pushing the

brake pedal at the same time lever (B) is pulled up.

6.8

The cutting units can be raised and lowered by

control lever (A) situated on the right hand side of

the operators seat and can be operated as follows:

To lift: Move the lever backwards and hold in position

until the units are at the required height.

To lower: Move the lever forwards and hold in this

position, the units will lower to ground level. The

lever automatically returns to a neutral position when

released.

NOTE: If any unit is raised out of work then lowered

into work again the blades will not rotate until the

mow foot switch is depressed.

NOTE: The units will only lift and lower when the

engine is running.

JACOBSEN AR250 Series CE

SAFETY AND OPERATORS MANUAL

GB-13

Table of Contents

Table of Contents