Roland HP 535 Owner's Manual page 37

7.
Select the tone (p.16).
Additionally, set any other desired modes such as Dual Play (p.17) and Split (p.18)
(Note 3).
8.
Press the [Rec] button to make the indicator lit.
The keyboard is put in record standby mode.
The [Play] button and Track buttonÕs indicators flash, as does the indicators on all the
[Track] buttons for the tracks being recorded to (Note 4).
Track
R 1
When recording begins, the [Track] buttons are selected automatically.
If you wish to cancel the recording, press the [Rec] button again. (Its indicator goes out.)
9.
If you want the metronome to sound while you are recording, press
the [Metronome] button.
Metronome sound is not recorded.
10.
Press the [Play] button.
After two measures of a count sound, recording begins (Note 5).
Recording will also begin if you start playing the keyboard without pressing the [Play]
button. In this case, no count sound is played.
11.
Press the [Play] button once again, and recording stops.
At this point, what is recorded to the Track button is shown below.
Track
R 1
Your Performance
12.
Pressing the [Play] button again starts playback of the song with your
recorded performance.
NOTE
Selecting a different song, the following appears in the display.
<HP-535>
If the buttons other than [Rec] button are pressed, display returus to previous screen.
Press the [Rec] button to erase the recorded data. Until you erase the recorded data,
you cannot select a different song.
2
2
Try Recording
<HP-335>
37