Watch And Stopwatch; Watch - Studer OnAir 2000M2 Operating And Service Instructions

5.13

Watch and Stopwatch

5.13.1

Watch

Date printed: 12.11.03
The watch and stopwatch functions are continuously displayed on the
right-hand side of the central screen (except when the keyboard or routing
pages are active).
The term "watch" refers to the time-of-day in analog and digital format,
the day-of-week, and the date in an abbreviated format.
The term "stopwatch" refers to both the fader and the user stopwatches.
The fader stopwatch measures the time the most recently used channel
fader has been opened. The user stopwatch works like a normal stopwatch
with START/STOP and RESET keys located directly below the central
screen.
Below, the HOME page with the watch and stopwatch displays and func-
tions is shown.
The watch gives a time, day-of-week, and date display. The normal time
reference is an internal, battery-buffered real-time clock (RTC). The RTC
continues to run even when the console is switched off. Therefore it is un-
necessary to set the watch at power-up. The RTC can also by synchronized
by an optional Time Sync Module connected to the control module bus. If
synchronization is established, the top right corner of the central screen
shows a small "S" (Sync OK).
Changes to the internal time reference and the time and date formats can
be made by the system administrator on the TIME page (MIXER SETUP,
SYSTEM CONFIG., TIME). For details, refer to
Both time and date can be displayed in two formats, as shown below:
Time Format
05:00:00 p.m.
17:00:00
Date Format
DD.MMM.YY
MMM-DD-YY
SW V 4.0
OnAir 2000M2 Digital Mixing Console
chapter
Digital Time Indication
12 hour time format
24 hour time format
Example
MO 20.MAR.02
MO MAR-20-02
Master Functions 5-23
12.2.5.