Mitsubishi Electric Jet Towel JT-SB116JH-G-NA Installation Manual page 7

Installation (Continued)
3.Remove the terminal cover mounting screw (1),
and remove the terminal cover.
※ Be careful not to lose the rubber bushing.
2
Warning
This hand dryer must have its own independent branch circuit using AWG #12 or #14 copper wire.
Use 120 Vac power.
Using the incorrect power supply may cause fi res, fumes, electric shocks or malfunctions.
Wire it to the terminal block. (No polarity)
1.Remove ⁹₁₆"(15mm) of wire sheath from the
end.
2.Position the back panel on wall so that the
3
back electrical inlet can be connected to the
pre-installed electrical conduit/tubing with
the ¹₂" (16mm) connector.
Rubber bushing
2³₄"(70mm)
⁹₁₆"(15mm)
Back Electrical Inlet
¹₂"(16mm)
Connector
Tighten to connect the
back panel and electrical
conduit/tubing.
− 7 −
Terminal cover
mounting screw
Terminal
cover
Terminal block
in. (mm)
min.
1
9 "(232)
8
Do not tighten the
screw in the lower
right corner at this
moment.
min.
1
14 "(368)
2
Back panel