Installing and Setting up the Machine > Default Settings of the Machine
Default Settings of the Machine
Before using this machine, configure such settings as date and time, network configuration, and energy saving functions
as needed. The Machine Setup Wizard is launched when the equipment is turned on for the first time after being
installed. Also, configure the following settings if necessary.
NOTE
The default settings of the machine can be changed in System Menu. For settings that are configurable from System
Menu, refer to
Setup and Registration (System Menu) (page
Setting Date and Time
Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the header of
the E-mail message. Set the date, time and time difference from GMT of the region where the machine is used.
NOTE
To make changes after this initial configuration, refer to
on page
8-27.
1
2
Display the screen.
Press the
[System
Menu/Counter] key, [
1
Configure the settings.
1
Set the time zone.
System Menu/Counter.
Date/Timer/Energy Saver
Date/Time
Date Format
Time Zone
+09:00 Osaka, Sapporo, Tokyo
Auto Panel Reset
8-1).
Date/Timer/Energy Saver on page 8-37
], and then [Date/Timer/Energy Saver].
System Menu/Counter.
System Menu
10:10
10/10/2013 10:10
DD/MM/YY
1/4
1
On
< Back
2-11
and
System/Network
Printer
3
System/Network
Date/Timer/Energy Saver
Adjustment/Maintenance
System Menu/Counter.
Date/Timer/Energy Saver - Time Zone
2
-12:00 International Date Line West
+13:00 Samoa
-11:00 Universal Coordinated Time-11
-10:00 Hawaii
10:10
5/5
2
Close
10:10
1/24
Cancel
OK