Fixing Of The Loading Floor; Adjustment Of The Safety Partition; Emergency Unlocking Of The Loading Area Door - Skoda 2011 Praktik Owner's Manual

194 Praktik

Fixing of the loading floor

Fig. 176 Loop for raising the loading floor/Fixing the loading floor with a plastic hook
You can fix the loading floor with a hook on the top edge of the boot lid cutout, in
order to e. g. reach the spare wheel.
– Raise the loading floor at the loop
located below the loading floor edge) to the top edge of the tailgate cutout
 fig. 176 on the right.

Adjustment of the safety partition

Fig. 177 Top support/bottom support of the safety partition
Only valid for some countries.
– Raise the loading floor part behind the safety partition.
– Unscrew on each side in the upper part of the body one screw
in the lower part one screw  fig. 177
 fig. 176
and fix it with a plastic hook (it is
 fig. 177
- right.
– Move the safety partition into the desired position. Always ensure that it has the
same distance and the same number of holes on both sides top and bottom.
– Screw on each side in the upper part of the body one screw and in the lower part
one screw.
– Have the tightening torque of the bolts checked with a torque wrench as soon
as possible. The tightening torque must be 20 Nm.
– Change the position of the cover of the luggage compartment floor behind the
safety partition so that it lines up with the new position of the safety partition.
– Fold the part of the loading floor again towards the bottom.

Emergency unlocking of the loading area door

If there is a fault in the central locking, you can open the loading area door as
follows:
– Remove the control cable and pull it.
– Press on the loading area door, in order to open it.
– Press back the control cable again.
-left and
Fig. 178 Emergency unlocking of the
loading area door