Skoda 2011 Praktik Owner's Manual page 22

The readout is shown in steps of 10 km. After lighting up of the indicator light for
the fuel reserve the display is shown in steps of 5 km.
The fuel consumption for the last 50 km is taken as a basis for calculating the range.
If you drive in a more economical manner from this moment on, the range will be
increased accordingly.
If the memory is set to zero (after disconnecting the battery), the fuel consumption
of 10 ltr./100 km is calculated for the range; afterwards the value is adapted accord-
ingly to the style of driving.
Distance driven
The distance driven since the memory was last erased appears in the display
 page 19. If you wish to calculate the distance driven as of a particular time, you
must erase the memory at this moment in time by pressing the button
windshield wiper lever  page 19, fig.
The maximum distance indicated in both memories is 1 999 km or in vehicles with
information display, it is 9 999 km. The indicator is set back to null if this period is
exceeded.
Average speed
The average speed since the memory was last erased is shown in the display in
km/hour  page 19. If you wish to determine the average speed over a certain
period of time, you must erase the memory at the start of the new measurement by
A
pressing the button on the windshield wiper lever
B
A zero appears in the display for the first 100 m you drive after erasing the memory.
The indicated value will be updated every 5 seconds while you are driving.
Current speed
The current speed which is identical to the display of the speedometer, is indicated
on the display A  page 15, fig.
3
Oil temperature
If the oil temperature is lower than 50 °C or if a fault in the system for checking the
oil temperature is present, three lines are displayed instead of the oil
temperature.
Using the system Safety
19.
 page 19, fig.
15.
Driving Tips
Warning against excessive speeds
This function enables you to set a speed limit and will notify you when this speed
limit is exceeded.
Set the speed limit when the vehicle is stationary
– With switch A
A
excessive speeds.
– Press the button
– Use the button
– Confirm the speed limit that was set with button
until the setting is saved automatically (the value stops flashing).
A
on the
B
This is how you can set the speed limit in 5 km/h intervals.
Set the speed limit when the vehicle is moving
– With switch A
A
– You can drive at the desired speed, e.g. 50 km/h.
A
– Press button
flashes).
If you wish to change the speed limit that was set, it is changed in 5 km/h intervals
(e.g. the accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
– Confirm the speed limit that was set by pressing button
19.
approx. 5 seconds until the setting is saved automatically (the value stops
flashing).
Changing or removing the speed limit
– With switch A
A
– Remove the speed limit with button
– Pressing the button
If you go faster than the speed limit that was set, you will be notified with an
acoustic warning. A Warning against excessive speeds appears together with the
set limit on the display.
The set speed limit remains stored even after switching off the ignition.
General Maintenance Breakdown assistance
Instruments and warning lights
 page 19, fig. 19, choose the menu point Warning against
A
to active the ability to set the speed limit (value flashes).
B
A
to adjust the required speed limit, e.g. to 50 km/h.
A
A
, choose the menu point Warning against excessive speeds.
to accept the current speed as the speed limit (the value
B
, choose the menu point Warning against excessive speeds.
A .
B
A again activates the change mode for the speed limit.
B
Praktik
21
, or wait approx. 5 seconds
B
A
again, or wait
B
Technical data