Pride Quantum 6000Z Series Owner's Manual page 13

Power Seat Installation
Your power chair may be equipped with the power
elevating seat option. While the seat itself may be any
one of the styles offered for this model, the way the
seat base attaches to the power base is different.
To install the power seat:
1. Place the seat plate interface bracket onto the
actuator. See fi gure 10.
2. Insert screws into the actuator and insert and
tighten the hardware. See fi gure 10.
3. Place seating system onto the seat plate interface
bracket and secure.
Transit Securement System (Optional)
If your power chair is equipped with a transit
securement system, it is equipped with manufacturer-
installed front and rear securement brackets and
positioning belt anchoring brackets. See fi gure 11.
Refer to the supplement provided with your power
chair for information on how to use the transit
securement system.
NOTE: In certain confi gurations, the transit
securement system is not available on power chairs
equipped with an HD option.
SEAT PLATE INTERFACE BRACKET
ACTUATOR
Figure 10. Power Seat Actuator
Quantum 6000Z Series
I V. A S S E M B L Y
Figure 9. Controller Routed on a Contour Seat
Figure 11. Transit System Securement Brackets
www.quantumrehab.com
WIRE TIES
TO POWER BASE
POSITIONING BELT
ANCHORING BRACKET LOCATIONS (1 OF 2 SHOWN)
SECUREMENT
BRACKETS
(3 OF 4 SHOWN)
13