Pride Quantum 6000Z Series Owner's Manual page 12

Seat Installation
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
Contour seats are attached to the power base with the
Universal Mounting System (UMS). The UMS consists
of universal parts that may be attached to the seat,
regardless of seat width or seat depth. The two main
components are aluminum extrusions mounted to the
seat base. These extrusions attach to a pair of trapeze
bars that are mounted to the power base. See fi gure 7.
NOTE: If your power chair is equipped with a Synergy
Seat or a TRU-Balance Power Positioning System,
refer to the information provided in separate manuals.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See fi gure 7.
2. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
3. Flip the seat latch safety down. See fi gure 7.
WARNING! Make sure the seat latch
safety is fl ipped down before using your
power chair.
4. Install the controller and route the harness to the back
of the power base. See fi gures 8 and 9.
5. Loosen the rear shroud fasteners and remove the rear
shroud. See fi gure 2.
6. Plug the controller connector into the power base.
See fi gure 3.
7. Replace the rear shroud and tighten the rear shroud
fasteners. See fi gure 2.
8. Secure the controller harness to the armrest receiver
with wire ties (contour seats only). See fi gure 9.
MANDATORY! Prevent controller harness
damage! Use correct tie-down points
for controller harness. Avoid routing
the controller harness on the outside
of the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
12
I V. A S S E M B L Y
Figure 7. Universal Mounting System and Contour Seat
Figure 8. Controller Routed on a TRU-Balance Power
Tilt
www.quantumrehab.com
SEAT LATCH
SAFETY
REAR
EXTRUSION
TO POWER BASE
UNLATCHED
LATCHED
FRONT
EXTRUSION
TRAPEZE BARS
Quantum 600Z Series