Table of Contents
Advertisement
Installing memory options
7.
Connect the cable to an internal channel connector on the ServeRAID adapter.
ServeRAID adapter
CPU
DASD
Memory
NMI
PCI
Bus
SP Bus
A B C
Event Log
Power
Supply
Non Red
1 2 3
Over Spec
Fan
Temp
Before you install memory, review the following:
•
The DIMM options available for your server are 128 MB, 256 MB, 512 MB, and 1
GB. Your server supports a maximum of 16 GB of system memory.
•
When 4 GB of memory is installed in the server, the amount of usable memory
will be reduced depending on the system configuration. A certain amount of
memory must be reserved below 4 GB for system resources. The usable memory
is reduced again when 16 GB of memory is installed. The BIOS will display only
the amount of memory available to the operating system.
•
Your server comes with a minimum of 512 MB of memory installed in bank 1.
When you install additional DIMMs, be sure to follow the DIMM installation
order in Table 2.
Table 2. DIMM installation order.
Set of 4 DIMMs
Bank 1 (shipped as standard)
Bank 2
Bank 3
Bank 4
Install DIMMs in these connectors:
J1, J5, J9, J13
J2, J6, J10, J14
J3,J 7,J 11,J 15
J4, J8, J12, J16
Chapter 2. Installing options
9
Advertisement
Table of Contents
