IBM eServer 350 xSeries Installation Manual page 30

You can turn off the server in several ways:
•
•
18
IBM xSeries 350: Installation Guide
You can press the power-control button on the front of the server to turn off the
server.
Note: After turning off the server, wait at least five seconds before pressing the
power-control button to turn on the server again.
Statement 5
CAUTION:
The power control button on the device and the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one
power cord. To remove all electrical current from the device, ensure that all power cords
are disconnected from the power source.
You can disconnect the server power cords from the electrical outlets to shut off
all power to the server.
Note: Wait about 15 seconds after disconnecting the power cords for your
system to stop running. Watch for the system-power light on the
information panel to stop blinking.