Brita Zip FL3000 Instructions

High performance water filter system

Zip FL3000 High Performance Filter System by BRITA

Installation and Operating Instructions

Issued March 2007

Please read these instructions carefully before commencing installation of the FL3000 high performance filter system.

Please leave these instructions with the end user after installation.

Table of Contents

Need help?

Do you have a question about the Zip FL3000 and is the answer not in the manual?

Page 1 Zip FL3000 High Performance Filter System by BRITA Installation and Operating Instructions Issued March 2007 Please read these instructions carefully before commencing installation of the FL3000 high performance filter system. Please leave these instructions with the end user after installation.
Page 2: Parts List
Zip FL3000 provides filtration down to 10 microns and may be used on its own with the Hydrotap’s internal filter blanked off using the blanking plug supplied in the installation kit.
Page 3 Note: The pressure housing and filter head of the Zip FL3000 system are designed for a service life of 5 years and bear a production date. Exchange must be carried out after 5 years (production date plus 5 years, i.e. if “06/03” is shown, exchange must take place in June 2008 at the latest).
Page 4 Replacing the Zip FL3001 Filter Cartridge Examine all dismantled parts carefully. Defective parts must be replaced and any soiled parts cleaned carefully. Turn the shut-off valve (4) on the filter head (2) to “OFF” and close the water supply. Draw approximately one litre of water from the appliance to de-pressurise the system. Switch off the power supply to the appliance.