Call Waiting - Panasonic KX-HDV330 Operating Instructions Manual

Removing a Party from the Conference
During a conference, you can remove other parties from the conference. However, this operation is
available only during conference calls you initiate.
1. During a conference call, press
2. Press / /[HOLD] again to show the conference parties on hold.
3. Tap / : Select the party to remove.
4. Talk to the party and go on-hook to end the call.
5. Press / /[HOLD].
Ending a Conference Call
To end the conference call, go on-hook.
Mute
You can disable the microphone or the handset to consult privately with others in the room while listening
to the other party on the phone through the speaker or the handset.
To set/cancel
1. Press /[MUTE/AUTO ANS].
Note
R When the icon is displayed in the status bar, Mute is on.
R During Mute, even if you switch from/to speakerphone, Mute will continue.
R During Mute, even if you connect/disconnect a headset, Mute will continue.

Call Waiting

During a conversation, if a second call arrives, you will hear a call waiting tone. You can answer the
second call by disconnecting or holding the current call.
This is an optional telephone company service. You can receive a call waiting tone and the caller's
information. For details, contact your phone system dealer/service provider.
To disconnect the current call and then talk to the new party
1. Go on-hook.
2. Go off-hook.
To hold the current call and then talk to the new party
1. Tap "Voice Call".
Off-hook Monitor
During a two-party conversation with the corded handset, you can allow other people to listen to the
conversation through the speaker while you continue the conversation using the corded handset.
To start/To cancel
1. Press /[SP-PHONE] during a conversation.
Note
R When off-hook monitor is active, replacing the corded handset to its cradle enables hands-free mode.
/ /[HOLD].
During a Conversation
37