Installation The installation sequence is just reverse of removal.
NOTE :
Should not be loose clutch side cover, screw M6 and spring seat after installation.
•
Clutch gear should turn only one direction.
•
VENTO MOTORCYCLES
S U P E R C L U T C H I N S TA L L AT I O N
REMOVAL
Clutch gear comp. 1
Rolling needle bearing 2
Screw M6 3
Clutch hub 4
Pin 5
Rolling pole 6 spring bush 7 and spring 8
Clutch outside circle rubber 9
Spring seat 10
Clutch side circle 11
Rev no.01/ page 41of 84