Left Crankcase Accessories Installation - Vento Phantom R4i Service Maintenance Manual

L E F T C R A N K C A S E A C C E S S O R I E S I N S TA L L AT I O N
REMOVAL
NUT 8 Washer 7 Drive Impeller 6
Nut 15 CVT nut washer 14 Centric disc 13
V –Belt (16 Driven wheel disc assy. 12
Pin 2 Gasket 1
Bush 5 Drive wheel assy. 4
Starter driven gear 3
Starter spring plate 11
Kick starting gear assy. (10) Starting gear sector assy. 9
NOTE
►When installing starter gear wheel and kick start gear assy. Assemble with little grease; keep arrow mark on
transmission gear dead against crankshaft, align kick start gear dead against marking point on transmission
gear, carefully pull kick start shaft spring to correct position with special tool, be careful that spring doesn't
turn back; position starting spring correctly and tighten the nut with specified torque 10~12NM.
►When installing V-Belt, rotate driven wheel assy anticlockwise install V-Belt into groove of driven wheel ,
then cover driving impeller groove with V- Belt and install driven wheel assy. into input axes, and then
assemble centric disc, dish washer and nut.
►Finally, tighten lock nut (15)and nut 8 with specified torque 45~55NM and then release driven wheel
disc freely. Assembled bush slides freely and convex side of washer 7 and washer 14 should towards out
side.
VENTO MOTORCYCLES
Starting gear sector assy. 9 Kick starting gear assy. 10
Starter spring plate 11
Starter driven gear 3
Drive wheel assy. 4 Bush 5
Pin (2) Gasket 1
Drive Impeller 6 Washer 7 Nut 8
V-Belt 16 Driven wheel disc assy. 12
Centric disc 13 Washer 14 Nut 15
Rev no.01/ page 35of 84
INSTALLATION