Turning Off The Server; Working Inside The Server With The Power On - IBM eServer 380 xSeries Installation Manual

Turning off the server

Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power
source.
Complete the following steps to turn off the server:
Note: Turning off the server refers to the act of disconnecting the server from the
1. Refer to your operating system documentation for the proper procedure to shut
2. Press and hold the power-control button on the front of the server for several
3. Disconnect the server from the power source.

Working inside the server with the power on

Your server supports hot-plug, devices and is designed to operate safely while turned
on with the cover removed. Follow these guidelines when you work inside a server
that is turned on:
•
•
•
14
xSeries 380: Installation Guide
power source.
down the operating system.
Note: Each operating system is different. Some will allow an immediate
shutdown; others require an orderly shutdown procedure.
seconds. This will put the server into standby mode.
Note: After you turn off the server, wait at least 5 seconds before you turn on the
server again.
Avoid loose-fitting clothing on your forearms. Button long-sleeved shirts before
working inside the server; do not wear cufflinks while you are working inside the
server.
Do not allow your necktie or scarf to hang inside the server.
Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wrist
watches.