Working With Hot-Swap Power Supplies - IBM eServer 380 xSeries Installation Manual

8. Rotate the retention mechanism locking tab on the rear of the expansion slot into
9. Check the status lights above the PCI adapter after it is installed.
10. Configure the adapter, according to the instructions that come with the adapter.

Working with hot-swap power supplies

Before you continue with the power-supply replacement procedure, review the
following information.
Attention: To maintain proper system cooling, do not operate the server for more than
5 minutes without either a power supply or filler panel installed.
Notes:
1. The power-supply bays are, from left to right, 1, 3, 4, 2.
2. The illustrations in this document might differ slightly from your hardware.
place.
Note: If the green status light is lit, power is applied to the adapter and it is ready
for use. If the amber status light is lit, the adapter might be defective or not
installed properly.
1
Retention mechanism
3 4 2
Chapter 2. Installing options
9