Electrical Supply; Step 4: Test For Leaks - Monogram ZGG48N42 Installation Instructions Manual

ELECTRICAL SUPPLY

Models with rotisserie require 120V, 60Hz.
and connected to an individual properly
grounded branch circuit protected by a 15
amp circuit breaker or time delay fuse.
The power cord on the rotisserie is equipped
with a three-prong (grounding) plug which
mates with a standard three-prong grounding
wall receptacle to minimize the possibility of
shock hazard from this appliance.
If the electrical service provided does not
meet the above specifications, it is recom-
mended that a licensed electrician install an
approved outlet.
4
Step
Test for
Leaks
• Do not use the grill until all connections have
• Repeat leak test after each LP tank change.
• Check to be sure the main valve on the LP
• Make a soap solution of one part liquid
The valve panel must be removed to check the
valves and fittings.
• All control valves should be in the "OFF"
• Remove the knobs.
• On models equipped with Rotisserie, remove
• Remove the 4 screws holding the valve panel
• Pull the panel outwards and unplug the wires
• If the grill has an optional rotisserie burner,
10
WARNING
TEST FOR LEAKS
A complete gas tightness check must be
performed at the installation site. Do not
use a flame to check for gas leaks.
been leak tested.
tank or the shut-off valve is in the "OFF"
position.
detergent and one part water.
position.
the safety valve pushbutton and unscrew the
surrounding bezel.
to the grill.
from the back of the rotary igniters.
remove the screws holding the inspection
cover in place.
Installation
Outdoor Cooking Centers
DO NOT UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
• For 27" wide built-in grills, locate the
electrical outlet on the left hand side within
reach of the rotisserie's 72" power cord.
• For 36" and 48" wide built-in grills, locate
the electrical outlet on the right hand side
within reach of the rotisserie's 30" power
cord.
TO TEST:
• Apply the soap solution around the
connections, valve and tubing.
• Turn the gas supply on.
• Check all connections from the supply line
or LP tank up to and including the manifold
pipe assembly.
• If a leak is detected, turn gas supply to off
and tighten fittings. Turn the gas on and
check again.
• To re-install the valve panel, re-connect the
igniter wires and secure the panel with
original screws.