Dvd Test Mode - Aiwa VX-F20DV1 U Service Manual

DVD TEST MODE

1. How to Start Up Test Mode
While pressing the DISC button of the main unit, turn ON the power switch (main switch). At this time, keep pressing the DISC
button until all the indicators on the FL display tube light. (Refer to the following figure.)
After all the indicators on the FL display tube light for three minutes or longer, the display changes to the status display or the media
display.
2. How to Quit Test Mode
Turn OFF the power switch of the main unit or that of the remote control unit.
3. Functions
Status display and media display
After the DVD test mode starts up, the display of the FL tube changes to "SxxMxx".
"Sxx" shows the status.
Status
S41
S42
S43
S44
S45
S46
S47
S48
S49
"Mxx" shows the type of media.
Media type
M21
M22
M23
M24
M25
When any status (any number) other than what are shown in the above tables is displayed, the data is the illegal data.
Display example:
The following display has the following meaning.
S41 STOP
M21 NO DISC
STOP status of pickup at inner circumference
STOP status of pickup at inner circumference with resume data
PLAY status
PAUSE status
SKIP status
The status in which TOC reading is in progress
The signal that shows the end of the EEPROM write (This is not displayed in this model.)
Indication that status has not been determined yet
Indication of DISC END
Contents
NO DISC
CD-DA
VCD (Ver1.0 or Ver1.1)
VCD (Ver2.0)
DVD
Contents
– 98 –