Aiwa VX-F20DV1 U Service Manual page 11

8) Pull it lightly while keeping the edge of the Anode Cap
turned over. Visually confirm that the both hooks are
inserted and check the condition of hitching of the
shutter hook.
9) Remove hand from the rubber cap of the Anode Cap.
Note) Put on the edge of the Anode Cap without clearance.
10) Push the part of the skirt of the edge of the Anode Cap
lightly and set the rubber cap and CRT to be adhered.
11) Furthermore, reconfirm that the Anode cap adheres
closely to the CRT (See Fig-12).
* Refer to the "Wire Process method" for details of wire
process.
* When either FBT or anode cap is going to be replaced, be sure to replace both FBT and anode cap at the same time as
follows. (Because the anode cap cannot be removed any more if it is locked into the connector-type FBT.)
1. Remove the rubber cap at the tip end of the anode cap
assy.
2. Insert the terminal at the tip end of the high tension lead of the anode cap assy as far as it can go until you feel the clicking
feeling.
3. Pull the anode cap assy gently upward (with 2 to 3 kg) in order to confirm that the connector is firmly connected. Then move it
down again. (The reason of pulling gently is to confirm that the connector is firmly connected. If it is pulled too strongly, the
connector can be broken.)
4. Press the rubber cap that is attached to the terminal side
of the anode cap assy, down to the flange. Note that the
rubber cap is not turned over. (See Fig-13.)
5. Remove the rubber cap of the focus wire.
6. Insert the top tip of the cable firmly and push down the
rubber cap so that the rubber cap cover the terminal
completely.
7. Insert the top tip of the screen wire firmly and secure it
by attaching it to the groove. (See Fig-14)
Rubber Cap
Rubber Cap
(White)
Focus Wire
(Red)
Screen Wire
Part of the skirt
Rubber Cap
Terminal
Fig-14
– 11 –
Anode cap
Anode Cap Assy
(White)
Focus Wire
Rubber Cap
(Red)
Screen Wire
Fig-12
Fig-13