Door Removal / Installation; Burner Installation - Napoleon HD81NT Installation And Operating Instructions Manual

32
6.2

DOOR REMOVAL / INSTALLATION

EN
THE DOOR LATCHES ARE PART OF A SAFETY RELIEF SYSTEM AND MUST BE PROPERLY
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
DO NOT INSERT FINGERS IN THE GAP BETWEEN THE DOOR AND THE FRAMING EDGE, THERE IS A RISK OF
Before the glass door can be removed, the trim with safety
screen must be removed, refer to "SAFETY SCREEN
REMOVAL / INSTALLATION" section.
A. Locate the door latches: one at each the left and
right side of the door between the main door and
framing edge.
B. Place the latch key onto the door latch. Pull
forward and away to disengage door latches.
C. Tilt the top of the door forward until you can grip the
sides of the door. Lift up and out of the bottom door
retainer.
D. To re-install the door, lift onto the bottom door
retainer, pivot the top of the door into the closed
position. Hold the door in place and resecure
the latches. NOTE: These latches make up the
spring relief system for the appliance. Ensure
they open freely and close sealed.
Reverse these steps to re-install the door and
trim with safety screen. Ensure the safety screen
is installed correctly.
6.3

BURNER INSTALLATION

See separate instructions accompanying burner assembly (sold separately).
W415-1406 / 11.19.14
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
INJURY DUE TO THE SPRING MECHANISM.
WARNING
!
WARNING
!
IMPORTANT: Once latches are engaged,
test to make sure that the door is secure
and will not fall forward.
75.1
Door Latch