Intercom - AT&T E2903B User Manual

HANDSET 1
12:45PM
INTERCOM TO:

INTERCOM

:
NOTE At any time, a
maximum of two hand-
sets can be used on an
intercom call, and
another handset
can be used on an out-
side call at the same
time.
Telephone operation
Intercom
Use the intercom feature for conversations between
handsets.
1. Press INT. The screen of the originating handset
will show INTERCOM TO:.
2. Enter the handset number of the destination handset (1,
2 or 3). The display will show CALLING HANDSET X.
The destination handset will ring, and its screen
will show HANDSET X IS CALLING.
NOTES:
•
Before the intercom call is answered, you can cancel the
intercom call by pressing
•
If the destination handset is not answered within 100
seconds or if it is in the directory or call log mode, or out
of range, the originating handset will show the message
NOT AVAILABLE.
3. On the ringing destination handset, press
PHONE
/FLASH
(0-9, * or #) to answer the intercom call.
:
NOTE On the ringing destination handset, pressing
or MUTE/
DELETE
To end the intercom call:
OFF
• Press
/CLEAR
-OR-
• Place either handset in the charger or telephone
base.
Handling incoming calls
The telephone will beep if you receive an outside call
during an intercom conversation. You can either:
PHONE
• Press
and answer the incoming call.
-OR-
• Press INT or
com connection without answering the incoming
call. The incoming call will continue to ring.
16 16
OFF/
, INT, SPEAKER, or any dial pad key
will temporarily silence the intercom ringer.
or INT on either handset.
to end the intercom call
/FLASH
OFF to disconnect the inter-
/CLEAR
or INT.
CLEAR
OFF/
CLEAR