Starting The Engine/Stopping The Engine - PowerLand PD3G4400E Owner's Manual

STARTING THE ENGINE/STOPPING THE ENGINE

Starting the Engine of Gasoline
1. Make sure that the AC circuit breaker is in the OFF position. The generator may be hard to
start if a load is connected.
2. Turn gas valve to "OFF" position.
3. Turn the fuel valve lever to the "ON" position.
4. Move the choke lever to the "CLOSE" position.
5. Make sure the auto throttle switch is in the "OFF" position, or more time will be required for
the engine to warm up.
6. Turn the engine switch to the ON position.
7. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTICE: Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter or housing.
With electric starter:
· Connect the ground cables of battery to the generator rear housing.
· Turn the engine switch to the "START" position and hold it there for 5 seconds or until the
engine starts.
·
When the engine starts, allow the engine switch to return to the O N position.
NOTICE: Operating the starter motor for more than 5 seconds can damage the motor. If the
engine fails to start, release the switch and wait 10 seconds before operating the
starter again.
If the speed of the starter motor drops after a period of time, it is an indication that the
battery should be recharged.
8. Move the choke lever to the OPEN position as the engine warms up.
9. If you wish to use the auto throttle system, turn the auto throttle switch to the ON position
after the engine has warmed up for 2 or 3 minutes.
NOTICE: Please don't start the generator on more than one fuel at the same time. If this
happens, shut off all three (3) fuel sources, turn the key to the "OFF" position, and pull
the cord 5-10 times. Then restart normally on any one (1) fuel.
17