Pre-Operation Check; Engine Oil - PowerLand PD3G4400E Owner's Manual

Appliances with large start-up power demands may
AUTO TH ROTTLE SWITCH
not allow the engine to reach normal operating rpm
when they are connected to the generator. Push the
auto throttle switch to the OFF position and connect
the appliance to the generator. If the engine still will
not reach normal operating speed, check that the
ON
appliance does not exceed the rated load capacity of
ON
OFF
the generator.
To avoid extended warm-up periods, keep the switch
OFF
OFF until the engine reaches operating temperature.
The auto throttle system is not effective for use with
appliances that require only momentary power. If the tool or appliance will be turned ON and
OFF quickly, the auto throttle switch should be in the OFF position.

PRE-OPERATION CHECK

Engine oil

NOTICE: Engine oil is major affecting engine performance and service life. Non-detergent and
2-stroke engine oils will damage the engine and are not recommended.
Check the oil level BEFORE EACH USE with the generator on a level surface with the engine
stopped.
SAE Viscosity Grades
AMBIENT TEMPERATURE
Use 4-stroke motor oil that meets or exceeds the requirements for API service classification SJ
or SG or SF or SN.
Always check the API SERVICE label on the oil container to be sure it includes the letters SJ
for SG or SF or SN.
SAE 10W-30 is recommended for general, all-temperature use. Other viscosities shown in the
chart may be used when the average temperature in your area is within the indicated range.
1. Remove the oil filler cap and wipe the dipstick clean.
2. Check the oil level by inserting the dipstick into the filler neck without screwing it in.
3. If the oil level is low, fill to the top of the oil filler neck with the recommended oil.
12