Service Error Message - Olivetti d-Copia 163MF Service Manual

(2) Service error message

Service error message
[PRINTER ERROR]
Service Call-####
[PRINTER ERROR]
Out of Memory
[PRINTER ERROR]
Engine Panic
[SCANNER ERROR]
Lamp Error
[SCANNER ERROR]
AFE R/W Error
[SCANNER ERROR]
Home sensor
Y107330-8
Contents
"####" means self-
diagnostic error code.
On-line printer jobs
are crowded.
The engine/high volt-
age PWB can not
establish communica-
tion between engine/
high voltage PWB and
the main PWB over 10
s.
Exposure lamp error
for scanner.
AFE read/write error
for scanner.
Scanner home posi-
tion sensor error for
scanner.
Causes
Self-diagnostic error Turn the power switch off and then back on
occurred. again. If this message still remains, follow
the self-diagnostic error code instruction.
(See P.1-4-2).
The data transferred Wait a while, and check again.
to the machine was
too complex to print
on a page.
Memory error. Turn the power switch off and then back on
again. If this message still remains, replace
the main PWB (See P.1-5-29).
Defective PWB. Replace the main PWB or engine/high volt-
age PWB. (See page P.1-5-29 or P.1-5-14)
Poor contact in expo- Reinsert the connector (See P.1-5-33).
sure lamp connector
terminals.
Defective exposure Replace the exposure lamp (See P.1-5-33).
lamp.
Defective inverter Replace the optical module unit
(See P.1-5-24).
PWB.
Defective FFC Reinsert the FFC. Also check for continuity
between main PWB within the FFC. If none, remedy or replace
and CCD PWB, or the FFC (See P.1-5-39).
improper connector
insertion.
Defective optical Replace the optical module unit
module unit. (See P.1-5-24).
Defective main PWB. Turn the power switch off and then back on
again. If this message still remains, replace
the main PWB (See P.1-5-29).
Defective main PWB. Turn the power switch off and then back on
again. If this message still remains, replace
the main PWB (See P.1-5-29).
Shipping lock is Turn the power switch off and slide shipping
locked. lock to unlock position (See P.1-2-4).
Poor contact in scan- Reinsert the connector (See P.1-5-37).
ner home position
connector terminals.
Defective FFC Reinsert the FFC. Also check for continuity
between main PWB within the FFC. If none, remedy or replace
and CCD PWB, or the FFC (See P.1-5-39).
improper connector
insertion.
Service Manual
Remarks
Check procedures/corrective measures
1-4-3