Lionel SD60 Owner's Manual page 20

TrainMaster Command Control operations
CAB-1 Remote Controller numeric keypad commands
W
hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. After you press the AUX1 button, you will be able
to press any numbered button until you address a different product. The corresponding
RailSounds sound system effects are in italic type.
Your locomotive keeps track of its fuel level. Higher engine run levels and/or heavy labor
use fuel at a faster rate. At various times, you will hear mention of the fuel level in CrewTalk
dialog. To add fuel via a "long reset," press and hold AUX1, 0 for at least three seconds.
When you release the button, the sounds will stop, and the engineer will confirm that the
tank is full. Stops and resets the locomotive. Resets the locomotive's direction to forward.
Refueling sequence.
Raises the overall master volume of the LEGACY RailSounds sound system. To
independently adjust the level of the background sounds only (e.g., the diesel roar and
brake sounds), tap AUX1 and then this key. Sound volume increases.
When adjusting the overall volume, you'll hear a single bell hit that gets louder or softer
with each volume adjustment. When the volume is at maximum, additional button
presses have no effect and won't play the bell. When adjusting the background sounds
(AUX1, then a volume key) you'll hear the prime mover volume change without a single
bell hit.
e
Engineer begins radio dialog, dispatcher replies (see page 17). CrewTalk communication.
Enters manual RPM mode and increases the RailSounds sound system RPM level (see
page 18). If the LEGACY RailSounds sound system is shut down (see 5 key below), AUX1,
3 activates a full LEGACY RailSounds sound system start-up while the locomotive is stopped
after pressing AUX1, 5 with track power on.
20