Iridium Pilot User Manual page 28

1. From the Configuration screen in the GUI, Under Port Forwarding Configuration, Click 'Add Rule' (see Figure
3.5). An administration page will open (Figure 3.8), shown below:
2. Enter /Select the following:
• The external port number to forward to the inside.
• The internal port number which will be receiving the data. Note: If you are redirecting as well, this
number will be different than the external port number.
• The IP address of the computer which is receiving the data. Note: This will need to be on the same
subnet as the Iridium Pilot IBSU.
• The protocol for the data: TCP or UDP.
Figure 3.8
Windows and Windows XP are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or
other countries.
3. Click OK. The updated configuration page with the newly added rule is displayed.
Figure 3.9
Windows and Windows XP are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or
other countries.
4. Add additional rules as needed.
Note: Rules can be turned on/off without having to be deleted.
24
Iridium Pilot User Manual