Sony DVP-CX995V Service Manual page 29

3. Mecha Aging
The mechanism aging is not supported.
4. Emergency History
### EMG. History ###
Laser Hours
CD
DVD
01.00 00 00 00
00 00 00 00
02.00 00 00 00
00 00 00 00
Select : 1-9 Scroll : UP/DOWN
(1: Last EMG.)
On the Test Mode Menu screen, selecting [4] displays the
information such as servo emergency history. The history
information from last "1" up to "10" can be scrolled with [Q] key or
[q] key. Also, specific information can be displayed by directly
entering that number with the ten-key pad from [1] to [9].
The upper two lines display the laser ON total hours. Data below
minutes are omitted.
Clearing History Information
Clearing laser hours
Press [DISPLAY] and [CLEAR] keys in this order.
Both CD and DVD data are cleared.
Clearing emergency history
Press [TOP MENU] and [CLEAR] keys in this order.
Initializing setup data
Press [MENU] and [CLEAR] keys in this order.
The data have been initialized when "Set Up Initialized"
message is displayed.
The EMG. History display screen will be restored soon.
5. Version Information
### Version Information ###
IF con Ver:x.xxx(xxxx)
B/E Ver:xxx xxx
F/E Ver:xx
Model
Region
Exit : RETURN
IF con : IC304 on the MB board
B/E : IC205 on the MB board
F/E : IC104 on the MB board
6. Video Level Adjustment
On the Test Mode Menu screen, selecting [6] displays color bars for
video level adjustment. During display of color bars, OSD disappears
but the menu screen will be restored if pressing the [RETURN] key.
xxh xxm
xxh xxm
00 00 00 00
00 00 00 00
00 00 00 00
00 00 00 00
Exit : RETURN
:DVP-CX995V
:xxx(x)
DISPLAY SECTION
DISPLAY TEST MODE
Execute the Self Check Mode along the following flow.
START
I/F CON information
FL tube grid and segment check
SIRCS reception check
Key check
Jog and LED check
Keyboard check
FINISH
1. Entering the Display Test Mode
The Display Test mode starts if either of the following conditions is
satisfied.
Condition 1:
With the SELF_CHECK (pin oj) of the IF CON (IC304) on the
MB board kept "low", turn the power on. (Short the CL301)
Condition 2:
While pressing the key on the set when the set is in standby
x
state, press the [RETURN] t [DISPLAY] key on the remote
commander and the mode transits to the Self Check mode.
When the Self Check mode started, "TEST START" is displayed
on the FL tube for 2 seconds and then the Self Check proceeds to
the IF CON information display.
2. Releasing the Display Test Mode
To release the Self Check mode, disconnect the AC plug.
3. IF CON Information Display
When enter this mode, it displays as follows.
All segments turn on
Model type display
Destination display
Version display
ROM creation date display
If the [DISC/AMS] knob is pressed, the test proceeds to the following
FL tube GRID and SEGMENT check.
DVP-CX995V
29