Sharp LC-30HV4U Service Manual page 37

b) Adjustment on the TEST items
1 2 3 4 5 6 7 8 9 10 11 12 13 14
1 T E S T
2 O L E R R
3 L C D D A T A
4
5 C L R M O D E
6
7 C N F G
8
5. Changing data
In "adjustment item display", the items pointed by cursor can be changed using VOL UP/DOWN key.(Holding
down the key is effective.)
For the items in "LCD DATA", select the item and hit ENTER key. The ten's digit (leftmost digit) in the address
changes to red (others in green). Data change using VOL UP/DOWN key is enabled.
To move to the next digit, press CH UP key (or rightward cursor key). To go back to the previous digit, press CH
DOWN key (or leftward cursor key). Thus, 4 digits data can be entered.
When CH UP key is pressed while in rightmost digit, the cursor moves to the leftmost digit. When CH DOWN key
is pressed while in leftmost digit, the cursor moves to the rightmost digit.
After address data adjustment, press ENTER key to exit from 4-digit adjustment and change the entire "LCD
DATA" line to red letters. (Same status as item selection)
6. Key operation
1) Basic behaviors
Basic key behaviors are as follows.
Behavior
Upward cursor movement
Downward cursor movement Cursor down
Rightward cursor movement Cursor right
Leftward cursor movement
Data UP
Data DOWN
Set
Back to previous layer
Back (In bottom layer only)
2) Data UP/DOWN
For the item for which OSD display is available, switch the display.
Adjust the data with UP/DOWN operation. (Any value beyond the limit is replaced by the limit value.)
Output data processing
Data transmission for every UP/DOWN operation (Data related to peripheral controller IC)
Execution of the last memory data when key is off
While the key is held down, the second step is performed approx. 500ms after the key operation and, after this,
every single step of UP/DOWN is carried out sequentially at 135ms interval.
3) Cursor UP/DOWN
Select the adjustment item by pointing it with the cursor.
When upward cursor movement is done while the cursor is at the top item, the cursor goes to the bottom item.
(In the case of multiple pages, the cursor goes to the bottom item on the previous page.)
When downward cursor movement is done while the cursor is at the bottom item, the cursor goes to the top item.
(In the case of multiple pages, the cursor goes to the top item on the next page.)
While the key is held down, the second step is performed approx. 500ms after the key operation and, after this,
every single step of UP/DOWN is carried out sequentially at 135ms interval.
R E 0
0 0 0 0
W A I T
0
W A I T
E E P 0 0 0 0
W A I T
Keys
Remote controller Main unit
Cursor up CH UP
CH DOWN
Cursor left
VOL UP VOL UP
VOL DOWN VOL DOWN
ENTER INPUT
RETURN
ENTER INPUT
37
LC-30HV4U
LC-30HV4D