Sharp LC-30HV4U Service Manual page 15

7. Remove the system/control terminal retaining:
7-1. Remove the four hex head screws securing the terminals of the system and control cables (white).
7-2. Remove the two screws securing the terminal of the system cable (gray).
7-3. Remove the two rear chassis retaining screws.
8. Remove the PC I/F and SR units:
8-1. Remove the six PC I/F top shield retaining screws and remove the shield.
8-2. Remove the six PC I/F unit retaining screws and remove the unit.
8-3. Remove the two PC I/F bottom angle retaining screws and remove the angle.
8-4. Remove the two SR unit retaining screws and remove the SR unit.
9. Remove the rear chassis.
9-1. Remove the three tuner nuts.
9-2. Remove the 10 rear cabinet retaining screws and remove the rear cabinet.
10. Remove the three power unit retaining screws and remove the power unit.
PC I/F Top Shield
PC I/F unit
SR unit
8-4
8-1
8-2
8-3
PC I/F Bottom Angle
7-1
7-2
7-3
15
Rear cabinet
10
Power unit
LC-30HV4U
LC-30HV4D
9-2
9-2
9-2
9-1