All-Reset Procedure - Citizen D200 Setting Instructions Manual

5) Set the watch so that its transfer terminal will be in contact with the
central one of the three connection pins (See the figure below).
*Do not touch the three transfer terminals with the bare finger. If they are
touched, they may be stained to cause a transfer trouble.
How to disconnect:
*Hold the band of the watch, and carefully lift the left side of the watch.
*Before disconnecting the RS-232C cable, finish AQUALAND GRAPH and turn off the
power switch of the personal computer.

12. ALL-RESET PROCEDURE

After the battery is replaced or the watch operates or indicates abnormally,
perform the all-reset operation.
1) Push and hold the all four push buttons at the same time for 2 seconds, then
release them.
All the digital segments light up.
2) Push any one of the push buttons, then release it.
At this time, a confirmation tone sounds to notify the completion of
the all-reset operation.
* After the confirmation sound, the LED flashes 3 times.
3) The watch is set to the time and calendar mode, and it indicates Jan. 01,
MON., AM 12: 00.
Precautions for performing the all-reset operation
Since all the log data and profile data are deleted after the all-reset
operation is performed, transfer the data to a personal computer or record
them in a log book.
When releasing the four push buttons at the same time, if the user touches
the water sensor, the dot indicator indicates [CHEK]. Then, all the segments
light up. After this operation, perform the normal all-reset operation
Return to Table of Contents
Return to Table of Contents
While the data are being
transferred, the dot
indicator indicates 'BUSY".
If the transfer fails, the
dot indicator indicates
"ERR". In this case, check
PI each connection part,
and start the transfer