Table of Contents
Advertisement
<Measuring Time with the Timer>
1. Press button
to start timing from the set time.
B
2. Pressing button
B
Pressing button
B
continuation from the time when the timer was
previously stopped.
3. Pressing button
A
returns the timer to the set time.
<Use of Auto-Chronograph Measurement>
1. The auto-chronograph starts measuring time
automatically after the set time of the timer has
elapsed.
2. Pressing button
B
measurement repeatedly starts and stops the
auto-chronograph each time it is pressed.
3. Pressing button
A
stopped returns the timer to the timer set time.
<Timer Restart Function>
Pressing button
during timer or auto-chronograph
A
measurement immediately returns the timer to the
timer set time and timing is automatically restarted
from that set time.
during timing interrupts timing.
again restarts timing in
while the timer is stopped
during auto-chronograph
when the auto-chronograph is
<Switching Mode during Timer Measurement>
Measurement is continued even when switching to
a different mode by pressing button
or auto-chronograph measurement. When again
returning to the timer mode, time is displayed in
continuation from before the mode was switched.
However, when the auto-chronograph completes 24
hours of measurement, the timer returns to the timer
set display.
13. ALL-RESET PROCEDURE
Always make sure to perform the all-reset procedure
described below after replacing the battery. In addition,
there may also rarely be times when the watch does
not run properly or has an abnormal display due to
a strong impact or is subjected to static electricity
(such as when there is no time display showing or
when the alarm sounds continuously). Perform the
reset-all procedure in these cases as well.
3. Press any button. (A tone confirming operation
sounds and the watch will start to run.) This
completes the all-reset procedure.
After performing this procedure, make sure to
properly reset the time and each of the other modes
before using the watch.
14. PRECAUTIONS
Caution:Water Resistance Performance
There are several types of water-resistant watches,
as shown on the following table.
For correct use within the design limits of the watch,
confirm the level of water-resistance of your watch,
as indicated on the dial and case, and consult the
table.
*
(The unit "bar" is roughly equal to 1 atmosphere.)
*WATER RESISTANT (ANT) xxbar may also be indicated as W.R. xxbar
during timer
M
<All-Reset Procedure>
1. Press all four buttons
,
,
and
A
B
C
M
simultaneously. (The
entire display lights.)
2. Release all buttons.
Advertisement
Table of Contents
