Log Mode - Citizen D200 Setting Instructions Manual

[Change of mode indication]
After valid dive is finished
- Measurement and indication
in surface mode are started

10. LOG MODE

In this mode, the data automatically recorded in the dive mode can be checked.
Log data: (Can be checked in the log mode of the watch.)
Eight data of the maximum depth, diving time, month and date of diving,
diving No., diving start time, average depth, lowest water temperature, and
diving finish time.
The log data of up to 30 dives can be recorded.
o (If the3lst dive is performed, the oldest data is deleted data, and
the data of the latest 3O dives are recorded.)
o Profile data: (Cannot be checked with the watch. Transfer these data
to a personal computer and check them together with the other log
data.)
The profile data are the depths measured every 5 seconds and water
temperatures measured every 5 minutes in the diving mode.
If the log data contains the profile data, the dot indicator indicates "PLOG
The profile data of up to the latest 6 hours can be stored. If the total
diving time exceeds about 6 hours, the stored data are deleted from the
oldest one. Accordingly, it is recommended to transfer the profile data to a
personal computer before the total diving time exceeds about 6 hours.
LOG MODE
Indication mode when no data is recorded
Return to Table of Contents
After measurement and indication in
surface mode are finished
- Measurement and indication in
When Profile Data is Stored
Return to Table of Contents
surface mode are finished