Syntax SV266A User Manual page 62

If you want an incoming call on a modem to automatically resume the system
from a power-saving mode, use this item to specify the interrupt request line
(IRQ) that is used by the modem. You might have to connect the fax/modem
to the mainboard Wake On Modem connector for this feature to work.
Soft-Off by PWRBTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can
be resumed by Wake Up Alarms. This item lets you install a software power
down that is controlled by the power button on your system. If the item is set
to Instant-Off, then the power button causes a software power down. If the
item is set to Delay 4 Sec. then you have to hold the power button down for
four seconds to cause a software power down.
IRQ/Event Activity Detect
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
LPT & COM
HDD & FDD
PCI Master
PowerOn by PCI Card
Wake Up On LAN/Ring
RTC Alarm Resume
x Date (of Month)
x Resume Time (hh:mm:ss)
IRQs Activity Monitoring
↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓ → → → → ← ← ← ← : Move Enter : Select
F1:General Help
F7:Optimized Defaults
This item opens a submenu that enables you to set events that will resume
the system from a power saving mode.
IRQ/Event Activity Detect
VGA [OFF]
[LPT/COM]
[ON]
[OFF]
[Enabled]
[Disabled]
[Disabled]
0
0 0 0
[Press Enter]
+/-/PU/PD:Value:
F5:Previous Values
42
Item Help
Menu Level
F10: Save ESC: Exit
F6:Fail-Safe Defaults