Panasonic CF-M34 Series Reference Manual page 49

Setup Utility
Boot Menu
Exit Menu
Parameters
Save Values & Exit
Exit Without Saving Changes
Get Default Values*
Load Previous Values
Save Current Values
Refresh Battery
* This item may not be displayed when starting up the Setup Utility with the User Password.
Floppy Drive
Hard Disk Drive
CD Drive* 1
LAN*
2
* "CD Drive" indicates a CD-ROM drive with a USB connection.
1
* Not displayed when [Boot up from LAN] is set to [Disable].
2
The default order is as follows:
[Floppy Drive] [Hard Disk Drive]
To move a device up by one in the order, select the device with
F6 .
To move a device down by one in the order, select the device with
F5 .
NOTE
Boot First Menu
The device for starting up the operating system can also be selected during computer
start-up.
After the computer is turned on, the device selection display will appear when Esc is
pressed while "Press Esc to enter Boot First Menu" is shown.
When the setting of the [Boot] menu is changed, the selection screen display will also
change.
The Boot First Menu is displayed only when [Display Boot Menu] in [Security] menu is
set to [Enable].
Save Values & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Current Values
Refresh Battery
Exit the Setup Utility and save your changes to CMOS.
Exit the Setup Utility without saving your changes to CMOS.
Set the default settings.
Load previous values from CMOS for all Setup items.
Save your changes to CMOS.
Refreshing the Battery (
[CD Drive] [LAN].
page 28)
49
and , and then press
and , and then press