Panasonic SA-XH70PH Service Manual page 33

9.4.2. Error Code Table 2
Error Diagnosis
Code Contents
H01 Tray loading error
H03 Traverse motor
error
U11 Focus servo error
U702 HDMI/DVI I2C
communication
error
U703 HDMI/DVI
authentication
error
U704 HDMI/DVI SRM
error
U705 HDMI/DVI SRM
disk falsification
check error
F899 The communication
specification
disagreement
between
micro-processor
Description of error
The tray opening and closing is abnormal.
CLOSE and OPEN of the tray cannot be
carried out properly. Loading motor error,
DV5 LSI IC (IC8001) error.
The traverse is abnormal. (Traverse servo,
DV5 LSI IC (IC8001), TRV motor error.)
Focus coil, FE signal error. Disc may be
dirty.
HDMI/DVI HDCP non-HDCP compliance:
Occurs when the equipment is not
compatible with the HDCP receiver.
[HDCP: copyright protection technology.
Digital image signal encryption scheme.]
When authentication (HDCP) with the TV
side fails when connecting it with HDMI/DVI,
it is generated.
It is generated at the equipment to which the
TV set is connected with HDMI/DVI.
It is generated at the time of it is time when
illegal the SRM data of the reproducing disk
(verify error), when connecting it with
HDMI/DVI.
Unsuitable combination of number of
system com and panel com used.
(Firmware)
Automatic FL Display
33
Remarks
Press [OPEN/CLOSE] on
main unit for next error.
(OPEN time: OPEN
CLOSE OPEN
H01 at CLOSE: CLOSE
OPEN CLOSE H01)
Press [OPEN/CLOSE] on
main unit for next error.
Press [OPEN/CLOSE] on
main unit for next error.
(Unfinalized DVD-R is likely
to become U11.)
Press [OPEN/CLOSE] on
main unit for next error.
Press [OPEN/CLOSE] on
main unit for next error.
Press [OPEN/CLOSE] on
main unit for next error.
Press [OPEN/CLOSE] on
main unit for next error.
Press [OPEN/CLOSE] on
main unit for next error.