Reversing The Door (Option) - SUNWIND XC-60 Instruction Manual

Regulating the temperature
The position number refers to fig. 1.
It will take several hours for the refrigerator to reach normal operating temperature.
The temperature of the main compartment of the refrigerator is controlled by a
thermostat. The thermostat knob (E) should be set at 1-4. If a lower (colder)
temperature is desired, set the thermostat to a higher figure. Please note that too
much lower temperature might make vegetable or egg frozen..
Turning Off The Refrigerator
If the refrigerator is not to be used for some time:
1. Shut off any valve in the gas line to the refrigerator.
2. Empty the refrigerator. Defrost and clean it as described in the following
paragraph. It must be completely dry inside to avoid mold growth (if possible have
the door open).
3. Set the thermostat button to the minimum position;

REVERSING THE DOOR (OPTION)

How to reverse the door
Remove the lower hinge by loosening and removing the screws with scredriver(2).
Carefully lower the door and remove it.
Remove the three screws from the left top hinge(1) position, take the plastic part off the
hinge position.
Remove the three screws from the right top hinge and take off the hinge, insert the
plastic part, rivet the three screws thereafter.
Take off the lower hinge and fix it to the opposite side.
Take the door. Insert the lower hinge axle into the right bottom hole of the door.
Fix the spare hinge to the left top position of the cabinet. Adjust the door, make it
straight and in alignment with the cabinet.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket
might have to be reset. This will be good for seal to avoid any air escaping. If there is a gap
between the cabinet and the door gasket, set the gasket by gently pulling it out to seal the
gap. If necessary, you are recommended also to use the hair drier to warm the gasket to get
rid of the gap
.
47