Reversing The Door (Option) - SUNWIND XC-60 Instruction Manual

Regulating the temperature
Turning Off The Refrigerator

REVERSING THE DOOR (OPTION)

How to reverse the door
Remove the lower hinge by loosening and removing the screws with scredriver(2).
Carefully lower the door and remove it.
Remove the three screws from the left top hinge(1) position, take the plastic part off the
hinge position.
Remove the three screws from the right top hinge and take off the hinge, insert the
plastic part, rivet the three screws thereafter.
Take off the lower hinge and fix it to the opposite side.
Take the door. Insert the lower hinge axle into the right bottom hole of the door.
Fix the spare hinge to the left top position of the cabinet. Adjust the door, make it
straight and in alignment with the cabinet.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket
might have to be reset. This will be good for seal to avoid any air escaping. If there is a gap
between the cabinet and the door gasket, set the gasket by gently pulling it out to seal the
gap. If necessary, you are recommended also to use the hair drier to warm the gasket to get
rid of the gap
.
47