Sanyo VCC-HD5400P Service Manual page 17

6. The camera will automatically start to pan and tilt.
Check that "A1" is displayed in the IE window, and then
move camera and the cabinet main together until the
center of the chart and the center of the monitor screen
are aligned.
A "+" will be displayed at the center of the monitor
screen.
7. Run another IE on the computer, and connect to http://
192.168.0.2.
8. Move the lens in the Tele direction with
make fine adjustments so that the "+" in the center of
the screen is fully aligned with the center of the chart.
Use the OSD display at the upper part left of the screen
to make fine adjustments to the pan within the range of
40—50 and to the tilt within the range of 15—25.
1
2
9. Click ADJ "SET".
10. Check that "A2" is displayed in the IE window, and then
use the button to align the center of the chart with
the center of the monitor screen.
11. After adjustment is complete, click ADJ "SET" to reset
the setting.
If you make an error during adjustment, click ADJ "DEL" in
the IE window and repeat the adjustment.
2-6. Overwriting firmware from the calibration
software
Preparation:
PC with overwriting firmware copied to the preferred folder in
the HD.
Data: 3L1xxxxx.BIN (xxxxx: version)
Overwriting method:
1. It turns on power.
2. Connect the camera's USB terminal to the computer'
button, and
USB connector.
3. Double-click on the DscCalDi.exe.
4. Click the Firmware.
5. Choose the fimware file to use for overwriting, and click
the Yes.
6. Update is starting. The message will appear, and choose
OK.
7. After the update is complete, disconnect the USB cable
and turn the camera's power off.
Note:
Do not turn off the camera's power while the firmware is be-
ing updated.
- -
17
OK if partially overlapping
horizontally and vertically